增加Arbiter

增加配置文件mongod1,mongod2,mongod3分別為shard1，shard2，shard3三個set集合的arbiter。
復制代碼 代碼如下:
replSet=shard1
replSet=shard2
replSet=shard3

啟動mongod實例。
連接Primary.
復制代碼 代碼如下:
rs.addArb(“192.168.1.50:10001″)
rs.addArb(“192.168.1.50:10002″)
rs.addArb(“192.168.1.50:10003″)

移除Arbiter
復制代碼 代碼如下:
rs.remove(“192.168.1.50:10001″)

注意:最好移除結點時候先停掉服務，防止有特殊未知狀態出現。

Note:Before running the rs.remove() operation, you must shut down the replica set member that you're removing.
Changed in version 2.2: This procedure is no longer required when using rs.remove(), but it remains good practice.