MSVC2015驅動開發

2019-11-11 03:20:58

字體：大中小

來源：轉載

供稿：網友

開發環境搭建

預備

需要下列硬件：

調試主機：運行windows10 系統（本文為x64）調試目標機：運行windows10 x64 系統主機（本文為x64）（或虛擬機）兩臺機器之間的有互通的網絡有internet,可以下載符號文件

需要下列軟件

windows10 SDKwindows10 wdk(本文為10）Visual Studio 2015

搭建

連通網絡

打開調試目標機系統盤還原

電腦->屬性->高級系統設置->系統保護這里寫圖片描述

安裝 WDK Test Target Setup

根據調試目標機的系統類型，選擇相應的安裝包。其位置在 wdk 安裝位置： C:/PRogram Files (x86)/Windows Kits/10/Remote/選擇 x64 安裝包： C:/Program Files (x86)/Windows Kits/10/Remote/x64/WDK Test Target Setup x64-x64_en-us.msi復制安裝包到測試目標機，并安裝

設置MSVC2015

打開vc2015打開菜單：Driver->Test->Configure Devices…

點 Add New Device 這里寫圖片描述

點NEXT

點下一步，開始安裝這里寫圖片描述

安裝下面內容 Installing necessary components… Copying required files Task “Copying required files” completed successfully Configuring WDK Remote User Account Task “Configuring WDK Remote User Account” completed successfully Installing .NET Framework (possible reboot) Task “Installing .NET Framework (possible reboot)” completed successfully Installing VC Redist (x64) Task “Installing VC Redist (x64)” completed successfully Installing test automation (x86) Task “Installing test automation (x86)” completed successfully Installing test automation (x64) Task “Installing test automation (x64)” completed successfully Installing debuggers (x86) Task “Installing debuggers (x86)” completed successfully Installing debuggers (x64) Task “Installing debuggers (x64)” completed successfully Installing driver test framework Task “Installing driver test framework” completed successfully Registering logging components Task “Registering logging components” completed successfully Configuring TAEF test service to start automatically Task “Configuring TAEF test service to start automatically” completed successfully Configuring kernel debugger settings (possible reboot) Task “Configuring kernel debugger settings (possible reboot)” completed successfully Configuring computer settings (possible reboot) Task “Configuring coreboot)” completed successmputer settings (possible fully Creating system restore point Task “Creating stem restore point” compld successfully Complete